MPE/iX Error Messages Manual Vol 2 (32650-90879)

342 Chapter9
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
file
1018 MESSAGE **error** unknown device type
CAUSE The device type entered in the TYPE= parameter is
unsupported, or incorrectly specified.
ACTION Verify the type has been entered correctly, and is an HP-
supported device. The file IODFAULT.PUB.SYS contains
all currently supported devices. If your device is not in
IODFAULT, you must add it as a USER device.
Hewlett-Packard only supports devices in the IODFAULT
file.
1019 MESSAGE **error** device mode too long
1020 MESSAGE **error** illegal device mode for this device
CAUSE The device mode entered in the MODE= parameter is not
appropriate for this particular device.
ACTION Enter an appropriate mode. If necessary, check the
IODFAULT file for permissible modes.
1021 MESSAGE **error** This device is not supported.
CAUSE You have entered a product identification that does not
exist in IODFAULT.PUB.SYS. Usually, the error is a simple
entry mistake.
ACTION Enter the proper Hewlett-Packard product IDs. If
necessary, check for supported product IDs.
1022 MESSAGE **error** iopath level mismatch
CAUSE In specifying the MADDRESS command, the paths of the
FROM= and TO= parameters have different levels, for
example, MA 8.4.8 4.2. Usually, an entry mistake.
ACTION Correct the path entry
1023 MESSAGE **error** can't find record in Ioldev
configuration file
CAUSE SYSGEN cannot find a particular record in the
configuration data file. The program terminates.
ACTION Refer to the file system error for action to take.
1024 MESSAGE **error** # new devices must watch # old
devices
1025 MESSAGE **error** can't update record in Ioldev
configuration file
1026 MESSAGE **error** can't open I/O default file
1027 MESSAGE **error** iopath already exists
1029 MESSAGE **error** missing physical file for physical