MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 9 339
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
CAUSE The channel adapter (and possibly the bus converter(s) for
the path given by NMMGR for either the DCC device
adapter or the NM device adapter has not been defined in
SYSGEN. This causes the configuration of the DCC
devices to fail. This message also occurs when SYSGEN is
being used to create a configuration for a system with
devices at different addresses (for example, running
SYSGEN on a 935 to create a 950 configuration).
ACTION If the configuration is intended for the current machine,
add the appropriate channel adapter(s) and bus
converter(s). If the configuration is intended for another
machine, make sure that the channel adapters and bus
converters are set up correctly for that machine. If you are
also creating an NMMGR configuration for the target
machine, SYSGEN can be told to use that configuration for
validation purpose by issuing the RDCC command in the
SYSFILE configurator.
0431 MESSAGE **warning** path ! (from DCC) has a bad
component (too large, or non-numeric)
CAUSE The path specified in NMMGR for either the DCC devices
or the NS devices is invalid. It might be either too large, or
nonnumeric.
ACTION Change the path from within NMMGR to be valid.
0432 MESSAGE **warning** path name (from DCC) too long
CAUSE It is possible, though unlikely, that the path specified from
within NMMGR is too long to fit into SYSGEN's data
structures.
ACTION Shorten the path from within NMMGR.
0440 MESSAGE **warning** OUTDEV must equal LDEV: Correct
value used
CAUSE The output device must equal the input device for all
terminal devices. The LDEV number entered on the ADEV
or MDEV command is considered the input device for
terminals.
ACTION None required. SYSGEN has used the correct value.
0441 MESSAGE **warning** OUTDEV must be zero (0): Correct
value used
CAUSE All devices except for terminals and the streams device(s)
must have an output device of zero.
ACTION None required. SYSGEN has used the correct value.
1000 MESSAGE **error** class ! already exists
CAUSE The class name you have entered already exists.