MPE/iX Error Messages Manual Vol 2 (32650-90879)

336 Chapter9
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
an LVOL is made for a volume name that does not exist.
This message appears when you use the DVOL or MVOL
command to delete or modify a volume and specify a
volume name that does not exist.
ACTION Enter the LVOL command to see a list of existing volumes.
Usually, the error occurs when the volume name is
misspelled. If you are certain the volume name you
entered should exist and doesn't, exit the I/O configurator
and use the SHOW command to check that you are in the
proper configuration group. Verify that the name hasn't
been previously modified.
0408 MESSAGE **warning** Can't open offline list
device--online used
CAUSE Usually, this error message appears when the printer has
not been spooled out. The offline device, also, may be
powered off or has been disconnected.
ACTION Inform your operations personnel that the offline device
that you were attempting to use is unavailable. If the
device has not been spooled, they are able to start spooling
for you.
0410 MESSAGE **warning** class ! degraded to mode !
CAUSE The combination of devices that you have placed into the
given class force all devices in that class to operate in a
less than optimal manner. This is caused by combining
unlike devices (for example, a tape drive and a printer)
into the same class.
ACTION Although the devices still operate in the degraded mode, it
is best to only put devices of a similar type into the same
class. Review the named class and separate it into two
classes.
0411 MESSAGE **warning** class ! is of mode !--user mode
ignored
CAUSE Although the user requested a specific class mode for the
given class, the devices in the class do not allow that mode.
Instead, the mode displayed in the message is used.
ACTION If you feel that the class should accept the given mode, use
the LCLASS command to determine that devices are in the
class -- a device of a different type would cause the class to
reject your chosen mode. Remove any such devices from
the class.
0414 MESSAGE **warning** Not enough room for dcc devices
in class !
CAUSE Each class may only contain a finite number of devices. For