MPE/iX Error Messages Manual Vol 2 (32650-90879)

330 Chapter9
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
ACTION Remove excess DTCs and reboot.
MESSAGE DCC ERROR P-L, link name specified for DTS does not exist.
CAUSE The link name in DTS.DTC screen was not found. The name may be
incorrect in either the LINK screen or the DTC screen or the
NMCONFIG.PUB.SYS file may contain more than the supported two links.
ACTION Remove excess links and reboot.
MESSAGE DCC ERROR P-L, link name for specified DTS is not
available.
CAUSE Some error occurred during link configuration.
ACTION Usually the error is hardware related; the card is not in the configured
slot, the card is not connected to the LAN, and so on. There should be
another DCC error message displayed that relates to the link
configuration error. Check additional error messages.
MESSAGE DCC ERROR P-L, TOO MANY LINKS CONFIGURED.
CAUSE NMCONFIG.PUB.SYS contains more than the supported two links.
ACTION Remove excess links and reboot.
MESSAGE DCC ERROR P-L, message received on wrong subqueue.
CAUSE Valid message received on wrong subqueue: the message was rejected.
ACTION None.
MESSAGE DCC ERROR P-L, unrecognized message received. All junk
mail will
be rejected.
CAUSE Unrecognized message received.
ACTION None.
MESSAGE DCC ERROR P-L, internal DCC logic error
CAUSE Unknown.
ACTION Contact your local DCC support person.
MESSAGE DCC ERROR P-L, (DAM error status SSSSSSSS). LLIO path:
PATH
CAUSE IEEE802.3 DAM (for example, the link) reported an error during
configuration. Usually the error is hardware related; for example, the card
is not in the configured slot or the card is not connected to the LAN.
ACTION Fix and reboot the system.
MESSAGE DCC warning PL, add ldev to class failure (HILO status
SSSSSSSS, ldev LLL).
CAUSE Classes are not supported.
ACTION Remove class from all profiles and reboot.