MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 9 329
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
CAUSE The DCC surrogate was unable to read an NMCONFIG record, or the data
in NMCONFIG.PUB.SYS was not validated or is corrupted.
ACTION Validate NMCONFIG.PUB.SYS again (for example, VALIDATE DTS/LINK)
and reboot more information decode SSSSSSSS.
MESSAGE DCC ERROR P-L, configuration record data was invalid.
NM path: PATH
CAUSE data in NMCONFIG.PUB.SYS was not validated or is corrupted.
ACTION Contact your support personnel. Validate NMCONFIG.PUB.SYS again (for
example, validate the DTS/LINK) and reboot.
MESSAGE DCC ERROR P-L, (HILO status SSSSSSSS. ldev LLL).
CAUSE high-level I/O services reported status SSSSSSSS for logical device
number LLL. DCC employs HILO services configure_hilo_device,
allocate_device and ldm-port.
ACTION Logical device numbers <99 should not be employed by data comm
products.
MESSAGE DCC ERROR P-L, (buffer manager status SSSSSSSS).
CAUSE data comm buffer manager reported status SSSSSSSS.
ACTION check buffer-size and number-of-buffer fields in NMCONFIG.PUB.SYS. For
more information decode SSSSSSSS.
MESSAGE DCC ERROR P-L, (External procedure not found).
CAUSE Native library did not contain expected data comm manager procedure.
Either NMCONFIG.PUB.SYS or the image is corrupted.
ACTION Validate NMCONFIG.PUB.SYS again and reboot.
MESSAGE DCC ERROR P-L, (memory management status SSSSSSSS).
CAUSE memory management reported status SSSSSSSS. DCC could not acquire
memory. This is serious condition and requires the intervention of your
Hewlett-Packard Support Representative.
ACTION Contact your Hewlett-Packard Support Representative.
MESSAGE DCC ERROR P-L, (Ports status SSSSSSSS).
CAUSE Ports reported status SSSSSSSS. DCC employs ports procedures
create_port and extended_receive.
ACTION For more information, decode SSSSSSSS.
MESSAGE DCC ERROR P-L, time out on reply msg, descriptor MMM.
CAUSE DCC did not receive reply message MMM in the allotted time.
ACTION Contact your DCC support personnel.
MESSAGE DCC ERROR P-L, too many DTCs configured.
CAUSE NMCONFIG.PUB.SYS contains more than the supported ten DTCs.