MPE/iX Error Messages Manual Vol 2 (32650-90879)

328 Chapter9
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
"Nonclass" Errors
Run-Time Codes: System Activity Indicator
When the system is up and running, the LED display issues an alternating run-time
message code as FxFF, where "x" is a hexadecimal digit from 0-A. The digit represents the
percentage of non-idle time.
DCC Error Codes
Toward the end of system start, the data communication configurator (DCC) executes. This
creates the LINK and DTS managers defined in NMCONFIG.PUB.SYS. If the DCC completes
successfully, the following message is displayed:
DCC STARTUP - OK!
However, if an error occurs, one of the following error messages is displayed. These
messages contain a DCC error number and description.
In the messages below, the P-L number is a DCC procedure number and DCC location
number. These values are needed by your local DCC support person when a problem is
reported. The SSSSSSSS in some messages is an 8-digit hexadecimal value. MMM and LLL
are decimal values. PATH is a NMCONF path or LLIO physical path.
NOTE Currently, the last message issued to the console during a system startup is
DCC STARTUP - ERROR. This is not an actual error. Enter a
Return and the
system prompt MPE/XL: is displayed.
MESSAGE DCC ERROR P-L, (LLIO status SSSSSSSS).
CAUSE Low-level I/O services reported status SSSSSSSS. DCC employs LLIO
services io_config, io_get_frame, io_release_frame, io_get_timer, and
io_send.
ACTION For more information decode SSSSSSSS.
MESSAGE DCC ERROR P-L, (reply status SSSSSSSS, MSG descriptor
MMM).
CAUSE Reply message MMM contained reply status SSSSSSSS.
ACTION For more information decode MMM and SSSSSSSS.
MESSAGE DCC ERROR P-L, (NMCONF file error SSSSSSSS).
NM path: PATH
CAUSE NMCONFIG file may not exist, or it is locked by another entity.
ACTION check to see if NMCONFIG.PUB.SYS exists, if it's a NMCONF type file, or if it
is locked by another entity.
MESSAGE DCC ERROR P-L, (NMCONF record error SSSSSSSS).
NM path: PATH