MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 8 311
System Startup, Shutdown, and Configuration
Class Errors
ACTION Contact your Hewlett-Packard Support Representative.
2A MESSAGE No message. System halts. (E)
CAUSE Channel cannot identify a data parity error. (Wrong
MSTAT issued on error.)
ACTION Contact your Hewlett-Packard Support Representative.
2B MESSAGE No message. System halts. (E)
CAUSE Verification of the ME bit functionality on channel adapter
status register for address parity errors fails. (Channel
does not set ME bit on error.)
ACTION Contact your Hewlett-Packard Support Representative.
2C MESSAGE No message. System halts. (E)
CAUSE Channel cannot identify an address parity error.
ACTION Contact your Hewlett-Packard Support Representative.
2F MESSAGE No message. System halts. (E)
CAUSE A mid-bus I/O card is not found.
ACTION Contact your Hewlett-Packard Support Representative.
40 MESSAGE No message. System halts. (E)
CAUSE Channel cannot finish logchannel transaction. There is no
interrupt at the end of the transaction.
ACTION Contact your Hewlett-Packard Support Representative.
41 MESSAGE No message. System halts. (E)
CAUSE Logchannel status error occurs. The transaction requires
the device adapter to be the system controller, and it is
not.
ACTION Check Hewlett-Packard IB card switch setting. Contact
your Hewlett-Packard Support Representative.
42 MESSAGE No message. System halts. (E)
CAUSE Undefined logchannel status error occurs.
ACTION Contact your Hewlett-Packard Support Representative.
43 MESSAGE No message. System halts. (E)
CAUSE End of the Hewlett-Packard IB loopback test with
logchannel returns a bad status.
ACTION Contact your Hewlett-Packard Support Representative.
44 MESSAGE No message. System halts. (E)
CAUSE Subchannel is not readied after the logchannel operation.
ACTION Contact your Hewlett-Packard Support Representative.