MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 8 305
System Startup, Shutdown, and Configuration
Class Errors
Class Error 7: Memory Failure
Class Error 7
memory error messages takes the form:
7sxx
where:
s= slot number
xx = detailed error number.
NOTE The memory test takes about 1.5 seconds per MB of memory.
00 MESSAGE No message. System halts. (E)
CAUSE Undefined error occurs at the start of the test of this
board.
ACTION Contact your Hewlett-Packard Support Representative.
01 MESSAGE No message. System halts. (E)
CAUSE Either stuck bit occurs in I/O status register or cannot find
four contiguous words within the first 256 KB without a
single bit error.
ACTION Contact your Hewlett-Packard Support Representative.
02 MESSAGE No message. System halts. (E)
CAUSE Verification of the memory with its address fails. Second
possible cause of the error is the cache unit. Third possible
cause of the error is the TLB.
ACTION Contact your Hewlett-Packard Support Representative.
03 MESSAGE No message. System halts. (E)
CAUSE Pattern testing memory fails. Second possible cause of the
error is the cache unit. Third possible cause of the error is
the TLB.
ACTION Contact your Hewlett-Packard Support Representative.
04 MESSAGE No message. System halts. (E)
CAUSE Multiple bit error flag is set by single bit error. Second
possible cause of the error is the cache unit.
ACTION Contact your Hewlett-Packard Support Representative.
05 MESSAGE No message. System halts. (E)
CAUSE Multiple bit error flag is not set by multiple bit error.
Second possible cause of the error is the cache unit.
ACTION Contact your Hewlett-Packard Support Representative.