MPE/iX Error Messages Manual Vol 2 (32650-90879)

304 Chapter8
System Startup, Shutdown, and Configuration
Class Errors
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
C5 MESSAGE No message. System halts. (E)
CAUSE Macrocode detects possible failure of RAM5 U1401.
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
C6 MESSAGE No message. System halts. (E)
CAUSE Macrocode detects possible failure of RAM6 U1101.
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
C7 MESSAGE No message. System halts. (E)
CAUSE Macrocode detects possible failure of RAM7 U1301.
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
CA MESSAGE No message. System halts. (E)
CAUSE An error occurs during a series of arbitrary microcode
calculations. Areas of possible cause are the mapper
PROM or the math chips.
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
CC MESSAGE No message. System halts. (E)
CAUSE An error occurs which slows the execution of the
floating-point unit.
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
Class Error 5: Bus Protocol Failure
Bus protocol messages takes the form:
5sxx
where:
s= slot number
xx = detailed error number.
00 MESSAGE No message. System halts. (E)
CAUSE Undefined error occurs at the start of this test.
ACTION Contact your Hewlett-Packard Support Representative.