MPE/iX Error Messages Manual Vol 2 (32650-90879)

300 Chapter8
System Startup, Shutdown, and Configuration
Class Errors
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
08 MESSAGE No message. System halts. (E)
CAUSE An error occurs since a floating-point operation that
causes a trapping exception is immediately followed by a
coprocessor store with a T-register conflict. This store
should have been delayed until the trap completes,
reflecting the result of the trap.
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
09 MESSAGE No message. System halts. (E)
CAUSE An unanticipated trap occurs, possibly caused by a failure
of the r1 comparator or trap logic.
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
0A MESSAGE No message. System halts. (E)
CAUSE Test of conflict comparator fails.
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
0B MESSAGE No message. System halts. (E)
CAUSE An error occurs as coprocessor load of a nonzero number to
FPR (0), the status register, is executed and then a
floating-point operation that requires zero as an operand
is executed. This tests that the FP operation reflects an
operand of zero.
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
0C MESSAGE No message. System halts. (E)
CAUSE T-bit of FPR(0) is not set.
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
0D MESSAGE No message. System halts. (E)
CAUSE An error occurs as a floating-point operation with a zero
T-field is executed followed by a coprocessor store of the
status register. The status register should not have been
affected by the FP operation.
ACTION Contact your Hewlett-Packard Support Representative.
Remove the floating-point board, then reboot the system.
0E MESSAGE No message. System halts. (E)
CAUSE An error occurs as a coprocessor load to a reserved register