MPE/iX Error Messages Manual Vol 2 (32650-90879)

298 Chapter8
System Startup, Shutdown, and Configuration
Class Errors
ACTION Try booting with switch 3 in normal position. Contact your
Hewlett-Packard Support Representative.
0B MESSAGE No message. System halts. (E)
CAUSE General register 0 is not found to be zero at TOC or HPMC
save state routine.
ACTION Contact your Hewlett-Packard Support Representative.
0C MESSAGE No message. System halts. (E)
CAUSE Undefined error message occurs for HPMC in HPMC save
state routine.
ACTION Contact your Hewlett-Packard Support Representative.
0D MESSAGE No message. System halts. (E)
CAUSE Cannot verify checksum while downloading code from
EPROM on system monitor card.
ACTION Contact your Hewlett-Packard Support Representative.
0E MESSAGE No message. System boots. (W)
CAUSE Self-test completes with warning.
ACTION check warning message(s). Contact your HP
Representative if future problem occurs.
0F MESSAGE No message. System boots. (I)
CAUSE Self-test completes successfully.
21 MESSAGE No message. Self-test continues. (W)
CAUSE Verification of stable storage fails.
ACTION Contact your HP Representative if system halt occurs or
future problem encountered.
22 MESSAGE No message. Self-test continues. (W)
CAUSE Failure occurs while reading from stable storage.
ACTION Contact your HP Support Representative if system halt
occurs or future problem encountered.
28 MESSAGE No message. Self-test continues. (W)
CAUSE Failure occurs while reading from time-of-day clock.
ACTION Contact your HP Support Representative if system halt
occurs or future problem encountered. check time-of-day
entry during START routine.
Class Error 4: Coprocessor Failure
Coprocessor messages take the form:
42xx