MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 1 29
Vol. II Chapter 1
Loader, Native Mode
CAUSE Invalid file pointer was specified.
ACTION Check the specification of the file pointer.
217 MESSAGE The specified file does not contain a valid
identifier for the internal file format.
(LDRERR 217)
CAUSE The internal identification stamp of the file is invalid.
ACTION Rebuild the program/library file.
218 MESSAGE No entry point was found for the program
specified. (LDRERR 218)
CAUSE Can not find an entry point for the specified program file.
ACTION Rebuild the program file.
300 MESSAGE Failed to create the object for LOADER
globals. (LDRERR 300)
CAUSE Failed to create the system object for the LOADER globals.
ACTION Try rebooting the system. If this is unsuccessful, call your
Hewlett-Packard Representative.
301 MESSAGE Failed to create the system PLABEL TABLE.
(LDRERR 301)
CAUSE Unable to create the system PROCEDURE LABEL
TABLE.
ACTION Reboot. If this is unsuccessful, call your Hewlett-Packard
Representative.
302 MESSAGE Failed to obtain an entry for the system
PLABEL TABLE HEADER. (LDRERR 303)
CAUSE Unable to allocate the header entry in the system
PLABEL TABLE.
ACTION Reboot. If this is unsuccessful, call your Hewlett-Packard
Representative.
303 MESSAGE Failed to INIT the semaphore lock for the
system PLABEL TABLE. (LDRERR 303)
CAUSE Failed to intitialize the semaphore for the system
PROCEDURE LABEL TABLE.
ACTION Reboot. If this is unsuccessful, call your Hewlett-Packard
Representative.
304 MESSAGE The system XRT entry is off boundary. (LDRERR
304)
CAUSE The specified address of the system XRT entry is out of
bounds.
ACTION Check the address specified.