MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 7 245
Volume II Chapter 5
UPS
Operating System procedure when that procedure was
called by the UPS Monitor software.
ACTION Call your Hewlett-Packard service representative.
575 MESSAGE UPS Monitor system call error: Error status !
(Subsystem # !, Error # !) received from
procedure Find_Plabel_Info. (UPSERR 0575)
CAUSE This is a software-detected error condition that indicates
an error occurred in a call to the specified MPE/iX
Operating System procedure when that procedure was
called by the UPS Monitor software.
ACTION Call your Hewlett-Packard service representative
576 MESSAGE UPS Monitor system call error: Error status !
(Subsystem # !, Error # !) received from
procedure HPgetsysplabel. (UPSERR 0576)
CAUSE This is a software-detected error condition that indicates
an error occurred in a call to the specified MPE/iX
Operating System procedure when that procedure was
called by the UPS Monitor software.
ACTION Call your Hewlett-Packard service representative.
577 MESSAGE UPS Monitor warning: Too many UPS devices
have been configured in the system I/O
configuration files. The UPS Monitor can not
monitor all of them; it will monitor as many
as it can. (UPSWRN 0577)
CAUSE Incorrect system I/O configuration. The system I/O
configuration, generated by SYSGEN and NMMGR
configurators, contains more than 128 UPS devices, which
is the maximum number that the UPS monitor can handle
simultaneously.
ACTION Review and correct the system I/O configuration, reducing
the number of UPS devices specified in the configuration
to an acceptable number.
578 MESSAGE UPS Monitor system call error: Error status !
(Subsystem # !, Error # !) received from
procedure Start_Shut_NM. (UPSERR 0578)
CAUSE This is a software-detected error condition that indicates
an error occurred in a call to the specified MPE/iX
Operating System procedure when that procedure was
called by the UPS Monitor software.
ACTION Call your Hewlett-Packard service representative.
579 MESSAGE UPS Monitor logic error: UPS Monitor
attempted to create a "zero size" UPS Table.