MPE/iX Error Messages Manual Vol 2 (32650-90879)

240 Chapter7
Volume II Chapter 5
UPS
Pointer condition in its global table.
(UPSERR 0551)
CAUSE This is a software-detected error condition that indicates
an error in the UPS Monitor software or in some other
system software, or a system memory error.
ACTION Call your Hewlett-Packard service representative.
552 MESSAGE UPS Monitor system call error: Error status !
(Subsystem # !, Error # !) received from
procedure Abortio_Request. (UPSERR 0552)
CAUSE This is a software-detected error condition that indicates
an error occurred in a call to the specified MPE/iX
Operating System procedure when that procedure was
called by the UPS Monitor software.
ACTION Call your Hewlett-Packard service representative.
553 MESSAGE UPS Monitor logic error: During shutdown
processing, while aborting UPS I/O requests,
the UPS Monitor detected an invalid UPS Table
Entry. (UPSERR 0553)
CAUSE This is a software-detected error condition that indicates
an error in the UPS Monitor software or in some other
system software, or a system memory error.
ACTION Call your Hewlett-Packard service representative.
554 MESSAGE UPS Monitor logic error: During shutdown
processing, while
aborting UPS I/O requests, the UPS Monitor
detected an invalid count of UPS
I/O requests outstanding. (UPSERR 0554)
CAUSE This is a software-detected error condition that indicates
an error in the UPS Monitor software or in some other
system software, or a system memory error.
ACTION Call your Hewlett-Packard service representative.
555 MESSAGE UPS Monitor logic error: During shutdown
processing, the
UPS Monitor found that the UPS Monitor
operating state was invalid when the
shutdown event message was received. (UPSERR
0555)
CAUSE This is a software-detected error condition that indicates
an error in the UPS Monitor software or in some other
system software, or a system memory error.
ACTION Call your Hewlett-Packard service representative.
556 MESSAGE UPS Monitor logic error: During shutdown