MPE/iX Error Messages Manual Vol 2 (32650-90879)

234 Chapter7
Volume II Chapter 5
UPS
CAUSE This is a software-detected error condition that indicates
an error in the UPS Monitor software or in some other
system software, or a system memory error.
ACTION Call your Hewlett-Packard service representative.
520 MESSAGE UPS Monitor logic error: Attempt to specify
"no I/O request" when starting next UPS I/O
request. (UPSERR 0520)
CAUSE This is a software-detected error condition that indicates
an error in the UPS Monitor software or in some other
system software, or a system memory error.
ACTION Call your Hewlett-Packard service representative.
521 MESSAGE UPS Monitor logic error: Invalid Read request
count when starting next UPS I/O request.
(UPSERR 0521)
CAUSE This is a software-detected error condition that indicates
an error in the UPS Monitor software or in some other
system software, or a system memory error.
ACTION Call your Hewlett-Packard service representative
522 MESSAGE UPS Monitor logic error: Invalid I/O function
specified when starting next UPS I/O request.
(UPSERR 0522)
CAUSE This is a software-detected error condition that indicates
an error in the UPS Monitor software or in some other
system software, or a system memory error.
ACTION Call your Hewlett-Packard service representative.
523 MESSAGE UPS Monitor logic error: Attempt to start
next UPS I/Orequest when previous UPS I/O
request still running. (UPSERR 0523)
CAUSE This is a software-detected error condition that indicates
an error in the UPS Monitor software or in some other
system software, or a system memory error.
ACTION Call your Hewlett-Packard service representative.
524 MESSAGE UPS Monitor logic error: Attempt to start
more UPS I/O requests than there are UPS
devices being monitored. (UPSERR 0524)
CAUSE This is a software-detected error condition that indicates
an error in the UPS Monitor software or in some other
system software, or a system memory error.
ACTION Call your Hewlett-Packard service representative.
525 MESSAGE UPS Monitor system call error: Error status !
(Subsystem # !, Error # !) received from