MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 7 231
Volume II Chapter 5
UPS
0197)
CAUSE The specified UPS device reported a UPS "High Ambient
Temperature Shutdown" condition. The temperature of
the UPS hardware became too high to permit safe
operation, and the UPS turned itself off to prevent
equipment damage.
ACTION If the computer room has become too warm, take steps to
cool the room. If room temperature is not the problem,
there has probably been a hardware malfunction. Call
your Hewlett-Packard service representative.
198 MESSAGE UPS LDEV ! reports UPS "Overload" condition.
(UPSERR 0198)
CAUSE The specified UPS device reported a UPS "Overload"
condition. The equipment being powered by the UPS is
drawing too much power from the UPS AC output. If the
excessive power draw continues, the UPS may reach an
"Overload Shutdown".
ACTION Call your Hewlett-Packard service representative.
199 MESSAGE UPS LDEV ! reports UPS "High Ambient
Temperature" condition. (UPSERR 0199)
CAUSE The specified UPS device reported a UPS "High Ambient
Temperature" condition. The UPS has detected an
abnormally high temperature in the UPS hardware. If the
temperature rises further, the UPS may reach "High
Temperature Shutdown".
ACTION If the computer room has become too warm, take steps to
cool the room. If room temperature is not the problem,
there has probably been a hardware malfunction. Call
your Hewlett-Packard service representative.
200 MESSAGE UPS LDEV ! reports UPS "Battery Test Fail"
condition. (UPSERR 0200)
CAUSE The specified UPS device reported a UPS "Battery Test
Fail" condition. This is a hardware malfunction within the
UPS hardware. The UPS logic perceives that the UPS
battery is not working properly.
ACTION Call your Hewlett-Packard service representative.
201 MESSAGE UPS LDEV ! reports UPS "High Battery Voltage"
condition. (UPSERR 0201)
CAUSE The specified UPS device reported a UPS "High Battery
Voltage" condition. This is a hardware malfunction within
the UPS hardware. The UPS logic perceives that the UPS
battery is not working properly.