MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 6 223
Volume II Chapter 5
Threshold Manager
ACTION Make sure the file record size is 256 characters or less.
512 MESSAGE Unexpected error from the PRINTOPREPLY
intrinsic. (THMGRERR 512)
CAUSE An error occurred attempting to notify the console
operator of some event.
ACTION Enter the command again.
513 MESSAGE End-of-file encountered on OUTPUT file.
(THMGRERR 513)
CAUSE Encountered end of file condition on the output file during
the execution of a command.
ACTION Increase the size of the output file.
514 MESSAGE End-of-file encountered on INPUT file.
(THMGRERR 514)
CAUSE Encountered end of file condition on the input file during
the execution of a command.
ACTION Increase the size of the input file.
515 MESSAGE End-of-file encountered on $STDLIST.
(THMGRERR 515)
CAUSE Encountered end of file condition on the $STDLIST during
the execution of a command.
ACTION Exit the program and start the application again. Recreate
the output file with a greater number of records and try
again.
516 MESSAGE Unexpected error from FPOINT intrinsic.
(THMGRERR 516)
CAUSE Access of a file via the FPOINT intrinsic resulted in an
error.
ACTION Check the file system errors and correct the error. Try the
command again.
800 MESSAGE Threshold Manager process has already been
created.(THMGRWARN 800)
CAUSE An attempt was made to create the Threshold Manager
process when it was already active.
ACTION The Threshold Manager is already active and no further
action is required.
900 MESSAGE Resource is already in the ENABLED
state.(THMGRWARN 900 )
CAUSE An attempt was made to enable a resource when it has
already been enabled.