MPE/iX Error Messages Manual Vol 2 (32650-90879)

216 Chapter6
Volume II Chapter 5
Threshold Manager
ACTION Enter the correct threshold value for this resource. Use
the SHOW command to see what the current values are for
any resource.
204 MESSAGE The threshold value should be between 1 and
100. (THMGRERR 204)
CAUSE A threshold value greater than 100 or less than 1 was
entered.
ACTION Enter a threshold value between 1 and 100.
207 MESSAGE Threshold Manager must be ENABLED for this
command. (THMGRERR 207)
CAUSE An attempt was made to execute a command that requires
the Threshold Manager process to be enabled.
ACTION Enable the Threshold Manager using the ENABLEMANAGER
command.
208 MESSAGE An invalid control option was specified.
(THMGRERR 208)
CAUSE An invalid control option value was specified with this
command.
ACTION Enter the command again with a valid control value.
209 MESSAGE An invalid notification option was specified.
(THMGRERR 209)
CAUSE An invalid value for a notification option was entered.
ACTION Enter the command again with a valid notification value.
212 MESSAGE Cannot enter duplicate threshold values for a
resource. (THMGRERR 212)
CAUSE The threshold value entered is the same as a currently
configured threshold for this resource.
ACTION Check to make sure the resource is correct, then either
modify the current value or delete it and add it again.
300 MESSAGE Subsys !, Info: ! (THMGRERR 300)
CAUSE Unexpected error occurred, subsystem and subsystem
error displayed.
ACTION None. HP internal support required to rectify this
problem.
302 MESSAGE Parameter is missing. (THMGRERR 302)
CAUSE An input parameter to the command is missing.
ACTION Use the HELP facility for this command or use the manual
and enter the command again.
303 MESSAGE Parameter length is invalid. (THMGRERR 303)