MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 1 13
Vol. II Chapter 1
KSAM
KSAM
(Subsystem 143)
NOTE KSAM error messages are included with subsystem 143 (File System)
messages. Refer to chapter 4, File System (Native Mode), for listing of
messages.
1026 MESSAGE Type manager; an internal error occurred.
CAUSE You requested a lower level system service and this
reported an error to the type manager.
ACTION If the problem persists, contact your Hewlett-Packard
support engineer.
1079 MESSAGE TM_KSM_INVALID_OFFSET
CAUSE The file offset pointer calculated for the KSAM file is
invalid.
ACTION Close the KSAM file, store it to tape, and call your
Hewlett-Packard support representative.
1080 MESSAGE TM_KSM_UNEXPECTED_ERROR
CAUSE During an operation on a KSAM file, a non-file system
error occurred.
ACTION Close the KSAM file, store it to tape, and call your
Hewlett-Packard support representative.
6005 MESSAGE Type manager; invalid function code or
parameter.
CAUSE An FCONTROL or FDEVICECONTROL function, or one
of its parameters, is not valid for the particular device or
access method in which it was used. It may also be invalid
for any device (for example, out of range).
ACTION Check the intrinsic call for which the error is reported and
correct any errors in the calling sequence.
6006 MESSAGE Type manager; you specified a parameter value
that is more than the maximum specified for
this
function.
CAUSE Self-explanatory.
ACTION Use the MPE XL Intrinsics manual to verify the set of
acceptable parameters for a given function code.
6007 MESSAGE Type manager; you specified a parameter value