MPE/iX Error Messages Manual Vol 2 (32650-90879)

124 Chapter4
Volume II Chapter 4
System Aborts
727 MESSAGE The procedure INTERNAL_SEND can not send to
internal facility port; bad status from
SEND_MSG.
728 MESSAGE The PORT FACILITY PROCESS is not available
yet.
729 MESSAGE The procedure DELAYED_AWAKE_PROCESS can not
send the delayed awake message to PFP.
730 MESSAGE The decrement of the port's total freeze
count causes it to become negative.
731 MESSAGE The port is already totally frozen, but
partial freeze failed; no reason for this to
happen.
732 MESSAGE The procedure INITIATE_UNBLOCKED_MAKE_PRESENT
(2) can not get message frame for make
present port; bad status from GET_MSG_FRAME.
733 MESSAGE The procedures
INITIATE_UNBLOCKED_MAKE_PRESENT and
PORT_MAKE_PRES can not
cleanup the message on the make present port
and give it back to the message pool; bad
status from RETRIEVE_MSG.
734 MESSAGE The procedure BLOCKED_MAKE_PRESENT can not
get FREEZE reply from MEMORY MANAGER for
MAKE_PRESENT; bad status from EXTEND_RECEIVE.
735 MESSAGE The procedure BLOCKED_MAKE_PRESENT detected a
bad FREEZE reply message from MEMORY MANAGER.
736 MESSAGE The FREEZE count is zero; can not hold FREEZE
since port is not totally frozen.
737 MESSAGE The FREEZE count is zero; cannot release
FREEZE because the port must be totally
frozen when called.
738 MESSAGE The procedure CHECK_PORT_DESCRIPTOR detected
an unknown port type in the port descriptor.
739 MESSAGE The procedure ENABLE_TIMEOUT can not alter
the standard message port for time out; bad
status from CHANGE_SUBQUEUE.
740 MESSAGE The procedure ENABLE_TIMEOUT can not get
timer for time out; bad status from
GET_TIMER.
741 MESSAGE The procedure DISABLE_TIMEOUT can not access
the standard message port for time out; bad
status from PORT_INFO.