MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 4 119
Volume II Chapter 4
System Aborts
501 MESSAGE During a file open, the GUFD semaphore could
not be initialized.
CAUSE A call to CB_INIT returned bad status.
502 MESSAGE During a file open, the FLOCK semaphore could
not be initialized.
CAUSE A call to CM_INIT returned bad status.
503 MESSAGE During a file open, the FOPEN semaphore could
not be initialized.
CAUSE A call to CB_INIT returned bad status.
504 MESSAGE Prefetch of needed data for a READ/WRITE
request could not be made.
CAUSE VSM reported address or range given to be invalid or out
of bounds.
505 MESSAGE Attempted to CLOSE a file which is not OPEN.
CAUSE File system lock algorithm failed.
506 MESSAGE The procedure could not open the system
library (the NL).
CAUSE Boot image or LABEL TABLE is corrupted.
ACTION Take a system dump and reinstall if necessary.
508 MESSAGE CREATE_OBJECT failed to create the SM KSO.
509 MESSAGE The procedure was unable to obtain the HASH
TABLE lock.
CAUSE CB_INIT returned bad status trying to initialize the UFID
HASH TABLE semaphore; start image is bad.
ACTION Recreate the boot image. Take a system dump and call
your support representative.
511 MESSAGE The procedure was unable to obtain the LRU
lock.
CAUSE CB_INIT returned bad status trying to initialize the LRV
semaphore; start image is bad.
ACTION Recreate the boot image. Take a system dump and call
your support representative.
514 MESSAGE A pascal recover block was entered
unexpectedly.
CAUSE Cause is usually associated with software or hardware
traps which have been tripped because of invalid
addresses, invalid access rights, or arithmetic
underflow/overflow.
551 MESSAGE Offset of entry is not within the LABEL