MPE/iX Error Messages Manual Vol 2 (32650-90879)

108 Chapter3
Volume II Chapter 3
Printer, Tape and Spooler
error in attempting to read, write, or control its spoolee.
The spoolee stops immediately; an input spooler will
delete its currently ACTIVE spooled device file, while an
output spooler will close its currently ACTIVE spooled
device file. May be attempting a rewind on a magnetic tape
device without a tape mounted. This generally indicates a
hardware problem, but can also occur in response to an
ABORTIO command.
ACTION Try to restart the spooler STARTSPOOL
ldev . If the
problem persists, the device or the medium (disk,
magnetic tape) is faulty. If device is magnetic tape, check
that a tape is mounted.
24 MESSAGE SP
#nnn /STOPPED, SPOOLEE NOT ACCEPTING
CAUSE The specified
ldev is neitherjob-accepting nor
data-accepting, causing the input spooler to stop. It cannot
recognize further JOB or DATA commands.
ACTION Use the ACCEPT JOBS,
ldev command or the ACCEPT
DATA,
ldev command and STARTSPOOL ldev to restart
the input spooler.
25 MESSAGE STANDARD FORMS ON LDEV #
nnn
CAUSE You have special forms mounted on a device, and a device
file not requiring special forms is assigned to the device.
ACTION Reply to the message by entering either ~~=REPLY pin,
YES when standard forms are mounted or ~~=REPLY
pin, NO when special forms are mounted and printing is
to be deferred.
26 MESSAGE UNABLE TO ALLOCATE $STDLIST FOR J
nn JOB
WAITING
CAUSE $STDLIST not able to be allocated.
ACTION None.
27 MESSAGE LDEV #nnn Tape Has Lost Tension - MISLOAD
ERROR
CAUSE The leader on the tape is not long enough. It must be at
least 12 feet.
ACTION Load a new tape, or move the "Beginning Of Tape" marker
on the current tape.