MPE/iX Error Messages Manual Vol 1 (32650-90878)

76 Chapter2

Command Interpreter

(CIERR)

OMITTED. (CIERR 740)

CAUSE The command that you issued does not recognize one of

the parameters. It might be that you did not include a

delimiter (semi-colon, comma, period, or space) between

parameters.

ACTION Check the MPE/iX Commands Reference Manual, to

make sure that you did not omit a delimiter. If you did, ﬁll

the delimiter in.

741 MESSAGE ACCESS INAPPROPRIATE FOR USER. (CIERR 741)

CAUSE One of the access modes that you speciﬁed on the

command line is not allowed for users.

ACTION Check the allowable access modes in the MPE/iX

Commands Reference Manual and change the command.

742 MESSAGE ACCESS REDUNDANTLY SPECIFIED. LAST OCCURRENCE

USED. (CIERR 742)

CAUSE One of the access modes that you speciﬁed on the

command line was repeated. The last occurrence of the

access mode is the one that will be used.

ACTION This message is informational only.

743 MESSAGE EXPECTED ONE OF AS, BS, CS, DS, OR ES. (CIERR

743)

CAUSE You did not specify an acceptable priority.

ACTION Specify an acceptable priority level.

744 MESSAGE MAXPRI REDUNDANTLY SPECIFIED. LAST OCCURRENCE

USED. (CIERR 744)

CAUSE You speciﬁed the MAXPRI parameter twice on the same

command line. The last MAXPRI value that was speciﬁed is

the one implemented by the command.

ACTION This message is informational only.

745 MESSAGE MAXPRI INAPPROPRIATE FOR GROUPS. IGNORED.

(CIERR 745)

CAUSE The MAXPRI parameter cannot be speciﬁed for groups. It

was ignored.

ACTION This message is informational only.

746 MESSAGE CAPABILITY LIST REDUNDANTLY SPECIFIED. LAST

OCCURRENCE USED. (CIERR 746)

CAUSE You speciﬁed the CAP parameter twice on the same

command line. The last CAP list that was speciﬁed is the

one implemented by the command.

ACTION This message is informational only.