MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 67
Command Interpreter
(CIERR)
644 MESSAGE PREP STEP FAILED, NO RUN WAS DONE. (CIERR
644)
CAUSE Segmenter could not find all the pieces required to
generate an executable image and run it.
ACTION Check to see if all external calls are satisfied.
645 MESSAGE REQUIRED DUMP FILE NAME MISSING. (CIERR 645)
CAUSE Dump file name was not specified as part of the command
line.
ACTION Re-enter the command and supply a dump file name.
646 MESSAGE MUST BE A BACK REFERENCED FILE. (CIERR 646)
CAUSE The name specified is either not a formal file designator or
it is misspelled.
ACTION Re-enter the command and supply a valid formal file
designator.
647 MESSAGE DS SUBSYSTEM NOT FOUND. (CIERR 647)
648 MESSAGE UNABLE TO CREATE "BASIC" SUBSYSTEM. (CIERR
648)
649 MESSAGE UNABLE TO LOAD "BASIC" SUBSYSTEM. (CIERR 649)
650 MESSAGE UNABLE TO CREATE ! SUBSYSTEM. (CIERR 650)
651 MESSAGE UNABLE TO LOAD ! SUBSYSTEM. (CIERR 651)
652 MESSAGE UNABLE TO CREATE ! COMPILER SUBSYSTEM. (CIERR
652)
653 MESSAGE UNABLE TO LOAD ! COMPILER SUBSYSTEM. (CIERR
653)
654 MESSAGE UNABLE TO CREATE COMPILED PROGRAM AS PROCESS
FOR "GO" STEP. (CIERR 654)
655 MESSAGE UNABLE TO LOAD COMPILED PROGRAM FOR "GO"
STEP. (CIERR 655)
656 MESSAGE FILE COMMAND TABLE FULL, UNABLE TO DO
IMPLICIT FILE COMMAND. (CIERR 656)
CAUSE Too many file equations are set.
ACTION Remove some of the file equations using the RESET
command. Then, re-enter the command.
657 MESSAGE TOO MANY BACK REFERENCES TO FILE !. (CIERR
657)
658 MESSAGE ATTEMPT TO RUN SUBSYSTEM OTHER THAN APL WITH
APL CHARACTER SET. (CIERR 658)
659 MESSAGE TOO MANY PARAMETERS; EXPECTED JUST AN APL