MPE/iX Error Messages Manual Vol 1 (32650-90878)

64 Chapter2
Command Interpreter
(CIERR)
specified range.
617 MESSAGE DL SIZE VALUE MUST BE BETWEEN -1 AND 32767.
(CIERR 617)
CAUSE A value less than -1 and greater than 32767 was specified.
ACTION Re-enter the command and supply a value between the
specified range.
618 MESSAGE REQUIRES ONE OF IA, BA, PH, DS, MR, PM
CAPABILITIES. (CIERR 618)
CAUSE The command requires one of the above capabilities to be
present in order to execute.
ACTION Check the user, group, and account capabilities. If a
program was run check the program capabilities using the
VERSION program.
619 MESSAGE DID NOT RECOGNIZE CAPABILITY AS IA, BA, PH,
DS, MR OR PM. (CIERR 619)
620 MESSAGE DUPLICATE KEYWORD. SECOND VALUE TAKEN.
(CIWARN 620)
CAUSE A keyword was specified twice and its later value
overwrote its first value.
ACTION The second value specified overwrote the first one and the
command was executed.
621 MESSAGE PREP FAILED DUE TO SEGMENTER ERROR. (CIERR
621)
622 MESSAGE PROGRAM FILE ! NOT FOUND. (CIERR 622)
CAUSE An attempt was made to execute program that does not
exist.
ACTION Verify that the program exists or its name was entered
correctly. Check the output of LISTF for correct spelling of
the file name.
623 MESSAGE DEFAULT MAXDATA AND/OR DLSIZE USED. (CIWARN
623)
CAUSE The value specified for MAXDATA or DL parameters of
the RUN command was not correct. It was ignored and the
default value used.
ACTION Re-enter the command and supply the correct value for
these parameters. A default parameter value may not
yield the correct results.
624 MESSAGE UNABLE TO CREATE PROGRAM TO BE RUN. (CIERR
624)
625 MESSAGE UNABLE TO LOAD PROGRAM TO BE RUN. (CIERR 625)