MPE/iX Error Messages Manual Vol 1 (32650-90878)

58 Chapter2
Command Interpreter
(CIERR)
CAUSE You forgot to specify the lockword after the slash.
ACTION Re-enter the command and supply the lockword.
562 MESSAGE LOCKWORD > 8 CHARACTERS LONG. (CIERR 562)
CAUSE The name specified for the lockword is more than 8
characters long.
ACTION Re-enter the command and supply a lockword that is up to
8 characters long.
563 MESSAGE EXPECTED LOCKWORD; "@" NOT PERMITTED. (CIERR
563)
CAUSE "@" was specified instead of an alphanumeric lockword.
ACTION Re-enter the command and supply a completely
alphanumeric lockword.
564 MESSAGE EMBEDDED NON-ALPHANUMERIC CHARACTER IN
LOCKWORD. (CIERR 564)
CAUSE A control or unprintable character was typed as part of the
lockword.
ACTION Re-enter the command. Make sure that you do not type in
any control characters.
565 MESSAGE MISSING DELIMITER AFTER LOCKWORD. (CIERR 565)
CAUSE The command interpreter expected a delimiter after the
lockword but did not find it.
ACTION Re-enter the command and supply a delimiter after the
lockword.
566 MESSAGE GENERIC LOCKWORD IS NOT PERMITTED. (CIERR
566)
CAUSE A wild card character was used in place of the lockword.
ACTION Re-enter the command and supply a completely
alphanumeric lockword.
569 MESSAGE LOCKWORD NOT PERMITTED FOR FILENAME OF "@".
(CIERR 569)
570 MESSAGE FIRST CHARACTER IN VSD NAME NOT ALPHABETIC.
(CIERR 570)
CAUSE Volume Set Definition (VSD) name specified does not start
with an alphabetic character.
ACTION Re-enter the command and supply a valid VSD name.
571 MESSAGE VSD NAME MISSING. (CIERR 571)
CAUSE Volume Set Definition (VSD) name was not specified as
part of the command line.