MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 49
Command Interpreter
(CIERR)
397 MESSAGE WARNING: SAVE EXPECTED COMMA, FOUND
SEMICOLON. (CIWARN 397)
CAUSE You specified a semicolon ";" in place of a comma ",." Your
request was not granted and the temporary file was not
saved.
ACTION Reenter the command and supply a comma instead of a
semicolon.
398 MESSAGE UNABLE TO SAVE $OLDPASS AS SPECIFIED FILE,
SAVED AS ! (CIERR 398)
CAUSE Evidently, the file name you supplied as the second
parameter to SAVE command already exists.
ACTION Look for accompanying error messages. Reenter the
command, supply the new name assigned to $OLDPASS,
and specify a file name that does not exist as the second
parameter to SAVE.
400 MESSAGE RELEASE EXPECTED ONLY THE FILE NAME. (CIERR
400)
CAUSE You supplied more parameters than required.
ACTION Reenter the command and supply only the file name.
401 MESSAGE RELEASE REQUIRES ONE PARAMETER, A FILE NAME.
(CIERR 401)
CAUSE You did not supply the name of the file to be released.
ACTION Reenter the command and supply a file name.
410 MESSAGE ALTSEC REQUIRES AT LEAST A FILE NAME. (CIERR
410)
CAUSE You did not specify a file name. You must provide at least a
file name in order to change any security restrictions.
ACTION Provide a file name.
411 MESSAGE EXTRANEOUS PARAMETER TO ALTSEC. (CIERR 411)
CAUSE The ALTSEC command does not recognize one of the
parameters that you specified on the command line.
ACTION Check the MPE/iX Commands Reference Manual for the
valid ALTSEC command parameters.
420 MESSAGE LEVEL OF LISTF MUST BE -3,-1,0,1,2,3,4,6.
(CIWARN 420)
CAUSE Evidently, you specified a level number that is not one of
those listed. The system provided you with the same
listing produced by level two.
ACTION No action is required, unless you did not obtain the
desired information from the default LISTF display.