MPE/iX Error Messages Manual Vol 1 (32650-90878)

488 Chapter6
File System (Native Mode)
(Subsystem 143)
5018 MESSAGE A failure occurred during a switch between CM
and NM, or vice versa. This failure occurred
somewhere within Directory Services.
5019 MESSAGE Either no GUFD/PLFD was found for the user's
logon account directory, or the logon group's
group entry was not found in the account
directory.
5020 MESSAGE This error should be impossible to return. If
it is returned, then some unexpected error
was returned in a DIRECFIND. The exact MPE/iX
error number may be found on the error stack.
5021 MESSAGE The volume class name was specified as an
output parameter when volume searching was
determined to be by volume sets; not by
volume classes.
5022 MESSAGE The status parameter was pointing to an
invalid section of memory.
5023 MESSAGE The volume range and volume names
specification conflict. Some of the VNAMES
were not needed compared to the range;
therefore, the extra names were ignored.
5024 MESSAGE The KEYVAlue parameter used to specify the
desired units was outside of the range
VINFO_UNITS_MIN_PARM to VINFO_UNITS_MAX_PARM.
5100 MESSAGE HPVLMINFO is reserving error numbers 5000 to
5100.
5101 MESSAGE The PROCESS LOCAL FILE DESCRIPTOR TABLE is
full.
5102 MESSAGE The file number does not reside in the PLFD
TABLE.
5103 MESSAGE The file number specified is not within the
range of possible open files.
6000 MESSAGE Storage Management SIO is not ready. (FILE
SYSTEM ERROR -6000)
CAUSE A storage management error was detected.
ACTION Ensure the device is operating properly.
6001 MESSAGE Storage Management SIO undefined function.
(FILE SYSTEM ERROR -6001)
CAUSE A storage management error was detected.
ACTION Ensure the device is operating properly.
6002 MESSAGE Storage Management SIO other function. (FILE