MPE/iX Error Messages Manual Vol 1 (32650-90878)

486 Chapter6
File System (Native Mode)
(Subsystem 143)
CAUSE The device was positioning at the beginning of the
medium, an attempt to backspace the medium could not
be performed.
ACTION Do not try to backspace the medium when it is positioned
at its beginning.
1506 MESSAGE A tape IO operation failed because the end of
the medium was encountered.
CAUSE An attempt was made to execute a device operation
beyond the end of the medium.
ACTION Do not try to access the medium beyond the end of tape
mark. Rewind, mount another tape and try again.
1507 MESSAGE A tape IO request failed because the device
is not available for access.
CAUSE The specified device is not a valid one, or the device is
disabled or unconfigured.
ACTION Check for the accessibility of the device being accessed.
1508 MESSAGE An internal error occured while processing a
tape IO request.
CAUSE An unexpected trap occur due to a file system internal
error.
ACTION Contact Hewlett-Packard for support.
1509 MESSAGE A bounds violation error was detected while
processing a tape IO request.
CAUSE The address/parameter passed was inaccessible to the
caller.
ACTION Pass only addresses in accessible spaces.
5000 MESSAGE A keyword < 0 or > VINFO_MAX_KEYWORD, or = 1
was specified; such keyword numbers are not
currently supported.
5001 MESSAGE The keyvalue for the output buffer type is
outside of the allowable range of
VINFO_OUTPUT_MIN_PARM to
VINFO_OUTPUT_MAX_PARM.
5002 MESSAGE The output buffer keyvalue pointed to an
invalid range of memory for the user, or
wasn't at least 4 bytes large.
5003 MESSAGE The keyvalue for the volume range is outside
of the allowed range of VINFO_RANGE_MIN_PARM
to VINFO_RANGE_MAX_PARM.
5004 MESSAGE The keyvalue parameter pointed to an invalid
section of memory.