MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 5 377
Error Messages V i C 5
HPIVOLINFO
indicates that the device received a new
command that used the same Virtual Circuit
Number as a previous command that is still
executing.
CAUSE Possible intermittent problem in disk hardware, cabling or
interface hardware, or a system software error.
ACTION If the problem persists, take a system dump, and call your
Hewlett-Packard Representative.
312 MESSAGE DISK ARRAY HAS DISABLED A MECHANISM IN LDEV
#. NOW IN DATA RECOVERY MODE. NO DATA LOST OR
CORRUPTED. OPERATION MAY CONTINUE. PLEASE
PLACE SERVICE CALL SOON.
CAUSE A mechanism in the disk array has suffered a failure. The
disk array is in data recovery mode and no immediate
action need be taken on the part of the user.
ACTION This message will be repeated on the console once a
minute until the operator acknowledges that he has seen
it by replying 'yes' to it. A service call should be placed in
the near future.
313 MESSAGE ACKNOWLEDGE DISABLED MECHANISM IN DISK ARRAY
IN LDEV #
CAUSE This is the acknowledgement message which corresponds
to the repeating message regarding the disabled
mechanism in the disk array.
ACTION This message must be replied to (Y) in order to stop the
repeating message.
HPIVOLINFO
(Subsystem 163)
NOTE HPIVOLINFO error messages are included with subsystem 163 (Volume
Management) messages. Refer to the chapter on Volume Management, in
Volume II of this manual for explanations of messages.