MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 5 375
Error Messages V i C 5
(Subsystem 198)
ACTION Call your Hewlett-Packard Representative.
-183 MESSAGE CS80_UNKNOWN_COMMAND_ERR The hardware status
from the disk device could not be recognized
by the system software because the value of
the second byte of status was not one of the
legal values defined for the Command Error
status class.
CAUSE Hardware problem in the disk device or in the cabling or
interfaces between the disk device and the host system.
ACTION Call your Hewlett-Packard Representative.
-184 MESSAGE CS80_NO_SELFTEST_PERFORMED The disk array
controller on a disk array device that is a
"link device" (i.e. is directly connected to
the host system by fiber-optic cable) has
rejected a device-wide selftest command that
was issued by the host system.
CAUSE Diagnostic program software error. Diagnostic programs
should not issue device -wide selftest commands to disk
array devices when they are "link devices". The disk array
controllers are designed to reject such commands.
ACTION Check to see that the diagnostic program is being run
correctly. If it is, and this error persists, call your
Hewlett-Packard Representative.
-185 MESSAGE CS80_CONFIGURATION_FAULT During a device
power-on selftest, the disk array device
controller could not satisfy the device
configuration (operating mode) that was
specified by the settings of the device's
front-panel configuration switches.
CAUSE Device installation error or hardware failure. Either the
configuration switch settings are wrong, or the drive
modules are wrongly located in the disk array module
slots, or one or more drive modules have failed.
ACTION Check for and correct improper configuration switch
settings or drive module placements.Checkfor failed drive
modules. If none of these checks reveal and correct the
problem, then call your Hewlett-Packard representative.
-186 MESSAGE CS80_FIRMWARE_UPGRADE_MODE A host system has
issued a transaction to a disk array device
at a time when the device cannot perform the
transaction, due to a lack of operational
firmware in the disk array device controller.
CAUSE The host system, under diagnostic program control,
attempted to upgrade the controller firmware in the disk