MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 4 345
Error Messages V i C 4
Display During Jobs
Display During Jobs
During a job, FCOPY displays warning and error messages on the standard listing device.
It does not give you the option of displaying file information. When FCOPY encounters a
potential problem with a file, it assumes that the command was submitted as you intended
and attempts to perform the requested operation.
Types of Messages
This appendix lists, in numeric order, all FCOPY messages, their causes, and the actions
you should take to correct them.
Three types of messages may be received: error, warning, and status messages.
• Errors encountered during a job stream cause FCOPY to terminate. However, only the
command is terminated if the errors occur during a session.
• Warnings do not cause an FCOPY command to terminate. In a job, they set the JCW to
WARN.
• Status messages do not indicate errors, but simply provide information about what is
happening during the copying operation.
The following table lists the FCOPY error, warning, and status messages in numerical
order, along with a brief definition of each message and the recommended corrective
action, where applicable.
Error, Warning, and Status Messages
These are the messages you are likely to encounter when you use the FCOPY subsystem.
NOTE In the text,
* indicates a WARNING message
** indicates a STATUS message
MESSAGE < CONTROL Y >
CAUSE Acknowledges receipt of a
CTRL Y entered during a
session.
ACTION None.
MESSAGE READ ERROR FROM COMMAND INPUTFILE