MPE/iX Error Messages Manual Vol 1 (32650-90878)

326 Chapter4
Error Messages V i C 4
(Subsystem 121)
ACTION Call your support representative.
230 MESSAGE The error bit in the CS80 hardware status was
set, which indicates an UNRECOVERABLE DATA
ERROR. The sector number is entered into the
BAD SECTOR TABLE.
CAUSE Data was lost due to bad sectors.
ACTION Call your support representative.
231 MESSAGE The error bit in the CS80 hardware status was
set, which indicates more than one sector had
UNRECOVERABLE DATA ERRORS. The first bad
sector number is placed in the BAD SECTOR
NUMBER.
CAUSE Data was lost due to bad sectors.
ACTION Call your support representative.
232 MESSAGE The error bit in the CS80 hardware status was
set, which indicates an attempt to read
UNITIALIZED DATA.
CAUSE Data uninitialized at address location.
ACTION Call your support representative.
233 MESSAGE The error bit in the CS80 hardware status was
set, which indicates an attempt to write to a
"READ ONLY" device.
CAUSE Device does not allow writes.
ACTION Verify the device is active. Call your support
representative.
234 MESSAGE The error bit in the CS80 hardware status was
set, which indicates the heads are NOT LOADED
as yet.
CAUSE A transient not ready condition existed.
ACTION Power on the device. Call your support representative.
235 MESSAGE The error bit in the CS80 hardware status was
set, which indicates an attempt to SPARE
FAILED due to no more spare sectors
available.
CAUSE Spare command failed.
ACTION Call your support representative.
236 MESSAGE The error bit in the CS80 hardware status was
set, which indicates an attempt to access
UNFORMATTED MEDIA.
CAUSE Disk was not initialized.