MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 4 325
Error Messages V i C 4
(Subsystem 121)
CAUSE Software problem.
ACTION Take a system dump. Call your support representative.
223 MESSAGE The DEVICE MANAGER received a request which
it could not understand OR is not currently
supported.
CAUSE The application attempted an inappropriate action for the
device.
ACTION Take a system dump and call your Hewlett-Packard
Service Representative.
224 MESSAGE A message was received which is inappropriate
for the current DEVICE MANAGER state, (e.g.,
an I/O request prior to DOBIND).
CAUSE Software problem.
ACTION Call your support representative.
225 MESSAGE The transaction was aborted due to SYSTEM
POWERFAIL.
CAUSE Power failure occurred while transaction was active.
ACTION None.
226 MESSAGE The CYCLIC REDUNDANCY CHECK of the data
transaction failed.
CAUSE Transmission problem; possible cabling problem.
ACTION Verify cabling; call your support representative.
227 MESSAGE The ALINK DEVICE ADAPTER is indicating the
fiber-optic link is non-functional, possibly
due to a power failure.
CAUSE Fiber-optic connected disk interface broken. Maybe due to
power failure.
ACTION Monitor the process; if problem persists, call your support
representative.
228 MESSAGE The error bit in the CS80 hardware status was
set, which indicates an attempt to access
beyond the END OF VOLUME.
CAUSE Addressed block beyond volume range.
ACTION Should not occur with single volume devices. Call your
support representative.
229 MESSAGE The error bit in the CS80 hardware status was
set, which indicates an attempt to access
beyond an END OF FILE.
CAUSE A file mark was detected; should not occur on disks.