MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 4 323
Error Messages V i C 4
(Subsystem 121)
sector was also bad.
ACTION Call your support representative and try sparing block
once again.
206 MESSAGE Request was cancelled by an abort.
CAUSE May have been caused by a power failure.
ACTION None.
207 MESSAGE A TIMEOUT has occurred, indicating that the
drive is not talking to the manager.
CAUSE Device was not responding.
ACTION Check device and cabling; may be due to a power failure.
208 MESSAGE A request was made of the manager, but the
manager is currently LOCKED by another higher
manager (usually DIAGNOSTICS).
CAUSE Device accessed by diagnostics.
ACTION Terminate "sysdiag" session; try again.
209 MESSAGE An internal table entry in this manager was
inconsistent; couldn't get or release the
table entry desired.
CAUSE Software problem.
ACTION Take a system dump. Call your support representative.
210 MESSAGE An attempt to release a MESSAGE FRAME failed.
CAUSE System software problem.
ACTION Take a system dump. Call your support representative.
211 MESSAGE An attempt to SEND a message failed.
CAUSE System software resource depleted.
ACTION Take a system dump. Call your support representative.
212 MESSAGE An error bit was set in the ACCESS field of
the CS80 hardware status that is undefined.
CAUSE CS80 device status returned invalid information.
ACTION Call your support representative.
213 MESSAGE Either an error bit in the FAULT field of the
CS80 hardware status which is undefined was
set, OR the DEVICE ADAPTER MANAGER returned
LLIO_HW_PROBLEM status, OR Diagnostics
previously set the DEVICE MANAGER state to
BROKEN.
CAUSE May be hardware problem.