MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 4 321
Error Messages V i C 4
(Subsystem 121)
CAUSE Device did not respond when initialization was attempted.
ACTION Depends if device is supposed to be powered on.
22 MESSAGE The DOBIND was successful. However, the
initialization of hardware received a DEVICE
ERROR.
CAUSE Device responded with an initialization error.
ACTION Call your support representative.
191 MESSAGE The subsystem number in the received message
was incorrect, usually during configuration.
CAUSE Configuration problem.
ACTION Verify your configuration and call your support
representative.
192 MESSAGE A BIND request was received, but already was
bound.
CAUSE Configuration problem.
ACTION Verify your configuration and call your support
representative.
193 MESSAGE Data received from LOOPBACK did not match
original data.
CAUSE Hardware problem during loopback test.
ACTION Call your support representative.
194 MESSAGE A request was received which requires the
manager to be locked, but it is not locked.
CAUSE Diagnostics attempted destructive test on unreserved
device.
ACTION Call your support representative.
195 MESSAGE An UNBIND request was received to UNBIND from
incorrect HIGHER MANAGER port number.
CAUSE Unconfiguration process problem.
ACTION Call your support representative.
196 MESSAGE A DO_UNBIND request was received with the
incorrect LOWER MANAGER port number.
CAUSE Unconfiguration process problem.
ACTION Call your support representative.
197 MESSAGE The memory request to RELEASE MEMORY (during
Die request processing) failed.
CAUSE System software response problem.