MPE/iX Error Messages Manual Vol 1 (32650-90878)

302 Chapter3
Command Interpreter
(CIERR) 1901-12256
REPAIR. (CIERR 10641)
CAUSE The mirrored volume set to be split was undergoing a
repair at the time.
ACTION Wait for repair to complete before trying the split.
10642 MESSAGE VOLULME SET IN USE, VSCLOSE WITH ;SPLIT
CANNOT BE DONE. (CIERR 10642)
CAUSE The mirrored volume set to be split has files opened on it.
ACTION Log off all users from the volume set and retry the split.
10643 MESSAGE PARTVS=USER IS VALID ONLY FOR A SPLIT VOLULME
SET. (CIERR 10643)
CAUSE The PARTVS=USER parameter was used to VSOPEN or
VSCLOSE a volume set which is not split.
ACTION Repeat the VSOPEN or VSCLOSE command without the
PARTVS parameter.
10900 MESSAGE SPU SWITCH OVER PRODUCT NOT INSTALLED ON THIS
SYSTEM. (CIERR 10900)
CAUSE :SPUCONTROL, :SWITCHBACK, or :SWITCHOVER was
entered, but the SPU Switch Over product was not
installed on the system.
ACTION Install the SPU Switch Over product, and make sure the
SPUINFOP configuration file is in the correct
configuration group.
10901 MESSAGE BOTH PARTNERS IN THE MIRRORED VOLUME SET
!volset name MUST BE
PRESENT ON SYSTEM !sysname. (CIWARN 10901)
CAUSE An :SPUCONTROL SETUP, :SWITCHBACK, or
:SWITCHOVER command was entered, but the mirrored
volume set indicated in the message is missing one of the
mirrored partners. Both partners in a mirrored volume set
must be present on the system before volume sets can be
switched.
ACTION Wait for the missing partner to mount on the specified
system, then re-issue the command. If the user wishes to
stop mirroring for the volume set, enter the appropriate
command to suspend mirroring, close the volume set, and
re-enter the command.
10902 MESSAGE SYSTEM NAME GREATER THAT 8 CHARACTERS. (CIERR
10902)
CAUSE A :SWITCHOVER, or :SWITCHBACK was entered with a
system name that was greater that 8 characters long. The
maximum length allowed for system names is 8
characters.