MPE/iX Error Messages Manual Vol 1 (32650-90878)

30 Chapter2
Command Interpreter
(CIERR)
as a specification of the number of copies.
ACTION You must specify a positive number between 1 and 127 to
indicate the number of copies. To review the command
syntax, invoke the online Help facility or refer to the
MPE/iX Commands Reference Manual; then reenter the
command with the appropriate number of copies specified.
264 MESSAGE UNEXPECTED DELIMITER FOUND. DEVICE PARAMETER
SYNTAX IS DEV=[device][,[output
priority][,[number of copies]]] (CIERR 264)
CAUSE You have entered something that the system does not
recognize.
ACTION Check for syntax or spelling errors and reenter the
command. For more information about the command
syntax, invoke the online Help Facility or refer to the
MPE/iX Commands Reference Manual.
265 MESSAGE DISK PARAMETER OVERRIDES PREVIOUS DISK
PARAMETER. (CIWARN 265)
CAUSE You have included more than one disk parameter in your
command line; the system is warning you that it is using
the last one named.
ACTION If you do not wish the system to use the last disk
parameter named in your command line, reenter the
command, omitting the redundancy.
266 MESSAGE NUMBER OF RECORDS MUST BE BETWEEN 1 AND
2147483647. (CIERR 266)
CAUSE You have specified a number that is outside the acceptable
range of 1 to 2147483647.
ACTION Reenter the command, being sure to keep the number of
records between 1 and 2147483647.
267 MESSAGE NUMBER OF EXTENTS MUST BE AN INTEGER BETWEEN
1 AND 32. (CIERR 267)
CAUSE You have entered something that the system cannot accept
as a specification of the number of extents. You must
specify an integer between 1 and 32.
ACTION Reenter the command, specifying an acceptable number of
extents. To review the command syntax, invoke the online
Help Facility or refer to the MPE/iX Commands Reference
Manual.
268 MESSAGE NUMBER OF INITIALLY ALLOCATED EXTENTS MUST BE
AN INTEGER BETWEEN 1 AND !. (CIERR 268)
269 MESSAGE UNEXPECTED DELIMITER. SYNTAX OF DISK
PARAMETER IS DISC=[# of logical records][,[#