MPE/iX Error Messages Manual Vol 1 (32650-90878)

272 Chapter3
Command Interpreter
(CIERR) 1901-12256
9110 MESSAGE THE HPRESULT VARIABLE COULD NOT BE MODIFIED.
(CIERR 9110)
CAUSE The CALC command could not modify the HPRESULT
variable value due to variable management error already
displayed. Typically, the variable value exceeds 255
characters.
ACTION Reenter the command. The HPRESULT variable value
must be legitimate (less than 255 characters).
9111 MESSAGE THE INPUT VARIABLE COULD NOT BE
ADDED/MODIFIED. (CIERR 9111)
CAUSE The INPUT command could not modify the HPRESULT
variable value due to variable management error already
displayed. Typically, the variable value exceeds 255
characters.
ACTION Reenter the command. The HPRESULT variable value
must be legitimate (less than 255 characters).
9113 MESSAGE NO COPY WAS DONE. (CIERR 9113)
CAUSE You did not confirm the purging of the destination file
before copying.
ACTION Reenter the command and supply either a different
destination file name or confirm the deletion of the
destination file.
9115 MESSAGE FILE BLOCK SIZE CANNOT EXCEED 32767 BYTES.
(CIERR 9115)
CAUSE The file block size specified exceeds the maximum size of
32,767 bytes.
ACTION Reenter the command and specify a block size less than
32,767.
9116 MESSAGE ONLY LOCAL, PERMANENT, NON-SPOOLED DISK FILES
MAY BE COPIED. (CIERR 9116)
CAUSE Evidently, the file you are trying to copy does not meet the
restrictions mentioned above.
ACTION Check for misspelling in the file name. Reenter the
command and supply a file name that meets the above
restrictions.
9118 MESSAGE TARGET FILE COULD NOT BE PURGED. (CIERR 9118)
CAUSE The target file in the COPY command is protected and
cannot be purged.
ACTION Contact the creator of the file or your account manager.
9120 MESSAGE SYSTEM FILE NAMES CANNOT BE USED IN THE COPY
COMMAND. (CIERR 9120)