MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 3 271
Command Interpreter
(CIERR) 1901-12256
9087 MESSAGE THE COMMAND "!" EXCEEDS 36 CHARACTERS. (CIERR
9087)
CAUSE The command qualified by the HPPATH variable exceeded
36 characters. The qualified command is inserted in the
error message.
ACTION Look for a missing delimiter between the command and its
parameters. Then, reenter the command.
9090 MESSAGE THE FIRST CHARACTER IN THE COMMAND NAME MUST
BE ALPHABETIC. (CIERR 9090)
CAUSE The first character in the user command is not alphabetic.
User commands cannot begin with non-alphabetic
characters.
ACTION Retype your command using a valid name.
9091 MESSAGE THE COMMAND NAME IS MISSING. (CIERR 9091)
CAUSE This message is usually caused by the COMMAND or
HPICOMMAND intrinsic (nothing was provided in the
"cmdrange" buffer.
ACTION Supply a command in the "cmdrange" buffer.
9095 MESSAGE THE COMMAND FILE IS EMPTY. (CIERR 9095)
CAUSE The file you tried to execute as a command file does not
contain any commands.
ACTION Reenter the command and supply a command file that is
not empty.
9096 MESSAGE THE CI CANNOT WRITE TO OUTPUT FILE. (CIERR
9096)
CAUSE An FWRITE to $STDLIST failed. It's possible that the file
to which data is redirected is full.
ACTION If CI output is redirected to a file, make that file larger,
and make sure that write access is legal.
9098 MESSAGE NAME DOES NOT FIT INTO A LOCAL VARIABLE -
INTERNAL ERROR. (CIERR 9098)
CAUSE Unknown.
ACTION Reenter the command. If it fails consistently, contact your
system manager or support representative.
9103 MESSAGE THIS COMMAND IS NO LONGER SUPPORTED IN
MPE/iX. (CIERR 9103)
CAUSE The command entered is no longer supported in the
MPE/iX system.
ACTION Consult the MPE/iX Commands Reference Manual, for a
complete list of available commands.