MPE/iX Error Messages Manual Vol 1 (32650-90878)

266 Chapter3
Command Interpreter
(CIERR) 1901-12256
remove the NOTREE option.
9042 MESSAGE No PURGEDIR was done. (CIERR 9042)
CAUSE User replied "NO" to the prompt asking if is was OK to
purge the directory.
ACTION Respond "YES" or "ALL" to this prompt, or use the ;YES
option to acknowledge the purge and suppress the prompt.
9043 MESSAGE No match found for the pathname. (CIWARN
9043)
CAUSE A wildcarded dirname was specified, but no directories
match the pattern.
ACTION Use LISTFILE and/or choose a different wildcard pattern.
9044 MESSAGE Trailing slash at end of filename was
ignored. (CIWARN 9044)
CAUSE A syntax error was detected in the pathname.
ACTION Re-enter a legal pathname.
9049 MESSAGE MUST HAVE SM CAPABILITY TO SPECIFY A PARM
LESS THAN 0. PARM = 0 USED. (CIWARN 9049)
CAUSE System Manager (SM) capability is required to specify a
parameter value less than zero (0) when running the CI
without the PARM=value option.
ACTION None. The CI was executed with a PARM=0.
9051 MESSAGE PH CAPABILITY IS REQUIRED FOR PROGRAM
EXECUTION. (CIERR 9051)
CAUSE Evidently, you do not have PH capability which is required
to execute a program from inside another program.
ACTION If you are not at the root CI, use the EXIT command to
return to it. Then, reenter the command. If this problem
persists, consult with your account manager or system
manager about acquiring PH capability.
9052 MESSAGE CREATEPROCESS FAILED ON IMPLIED RUN COMMAND.
(CIERR 9052)
CAUSE The CREATEPROCESS intrinsic failed.
ACTION Reenter the command. If it fails consistently, contact your
system manager or support representative.
9054 MESSAGE THE COMMAND FILE CANNOT BE CLOSED. (CIERR
9054)
CAUSE The CREATEPROCESS intrinsic failed.
ACTION Reenter the command. If it fails consistently, contact your
system manager or support representative.