MPE/iX Error Messages Manual Vol 1 (32650-90878)

204 Chapter3
Command Interpreter
(CIERR) 1901-12256
ACTION Reenter command line specifying either AUTO or
NOAUTO.
3751 MESSAGE LOGFILE MUST END WITH "001" TO USE AUTO
(CIERR 3751)
CAUSE Logfile entry must end with "001".
ACTION Reenter logfile number.
3752 MESSAGE CHANGELOG NOT ALLOWED ON THIS OLD FILE (CIERR
3752)
CAUSE The original log file name does not follow conventions
(ending with a digit), so it can't be incremented with the
CHANGELOG command to create a new log file.
3753 MESSAGE LOG FILE DOES NOT END WITH "001" ONLY ONE
MEMBER IN SET (CIWARN 3753)
CAUSE Logfile entry must end with "001".
ACTION Reenter command line.
3754 MESSAGE CHANGELOG NOT ENABLED FOR THIS LOGID (CIERR
3754)
CAUSE Reference to LOGID is not enabled.
ACTION Enable the LOGID.
3810 MESSAGE LOG HAS EXACTLY TWO PARAMETERS. (CIERR 3810)
CAUSE Command only allows two parameters.
ACTION Check syntax.
3811 MESSAGE THE LOGID MUST BE 1 TO 8 CHARACTERS IN
LENGTH. (CIERR 3811)
CAUSE LOGID exceeds 8 characters.
ACTION Check syntax.
3812 MESSAGE FIRST CHARACTER OF LOGID MUST BE ALPHABETIC.
(CIERR 3812)
CAUSE Same as the message.
ACTION Check the syntax and reenter the command.
3813 MESSAGE NON-ALPHANUMERIC CHARACTERS NOT ALLOWED.
(CIERR 3813)
CAUSE A non-alphanumeric character was used.
ACTION Check the syntax and reenter the command.
3814 MESSAGE NO ACTIVE LOG PROCESS FOR THIS LOG ID. (CIERR
3814)
CAUSE Log referenced is not active.