MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 3 203
Command Interpreter
(CIERR) 1901-12256
ACTION Check command syntax.
3467 MESSAGE EXPECTED EITHER CQ, DQ, OR EQ. (CIERR 3467)
CAUSE Syntax error.
ACTION Check command syntax.
3468 MESSAGE EXPECTED ! AS A SEPARATOR BEFORE PARAMETER.
(CIERR 3468)
CAUSE Only a the specified delimeter (represented by a ! in this
message) can be used as a parameter delimiter.
ACTION Check command line syntax and make sure you are using
the appropriate delimiter. Then reenter the command.
3469 MESSAGE EXPECTED ! OR CARRIAGE RETURN AS A SEPARATOR
AFTER PARAMETER. (CIERR 3469)
CAUSE Only a the specified delimeter (represented by a ! in this
message) or a carriage return can be used as a parameter
delimiter.
ACTION Check command line syntax and make sure you are using
the appropriate delimiter or a carriage return. Then
reenter the command.
3470 MESSAGE QUEUE DESCRIPTOR DUPLICATELY SUPPLIED. (CIERR
3470)
CAUSE A duplicate in the command line has occurred.
ACTION Check command line syntax.
3471 MESSAGE QUEUE DESCRIPTOR MUST BE A NUMBER. (CIERR
3471)
CAUSE Queue Descriptor provided is not a number.
ACTION Check the command syntax line.
3472 MESSAGE THE BASE LIMIT PARAMETERS MUST BE BETWEEN 150
AND 255. (CIERR 3472)
CAUSE The BASE and LIMIT parameters must have values
between 150 and 255.
ACTION Correctly reenter command using appropriate values.
3473 MESSAGE THE MIN, MAX FILTER VALUES MUST BE POSITIVE
INTEGERS. (CIERR 3473)
CAUSE Positive intergers must be used.
ACTION Check command line syntax.
3750 MESSAGE AUTO AND NOAUTO SPECIFIED, DEFAULT IS NOAUTO
(CIWARN 3750)
CAUSE Both parameters were specified. Default was used.