MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 3 199
Command Interpreter
(CIERR) 1901-12256
3400 MESSAGE SYSTEM MONITOR IS ALREADY ENABLED. (CIERR
3400)
CAUSE Device referenced has been enabled.
ACTION User does not need to enable system monitor.
3401 MESSAGE COULD NOT ENABLE MEASIO. (CIERR 3401)
CAUSE Measurement Interface can not be enabled.
ACTION User cannot enable MEASIO.
3402 MESSAGE UNABLE TO GET DATASEG BUFFER FOR SYSTEM
MONITOR. (CIERR 3402)
CAUSE System monitor data segment buffer unable to be
accessed.
ACTION Check data segment table.
3403 MESSAGE SYSTEM MONITOR WAS NOT ENABLED. (CIERR 3403)
CAUSE System monitor has not been enabled.
ACTION Enable system monitor.
3404 MESSAGE TAPE ERROR ENCOUNTERED BY MEASIO. (CIERR
3404)
CAUSE The measurement interface has detected a problem with
the tape.
ACTION Check tape and tape drive.
3405 MESSAGE END OF TAPE ENCOUNTERED BY MEASIO. (CIERR
3405)
CAUSE The end of the tape has been detected.
ACTION Check tape and tape drive.
3406 MESSAGE SYSTEM MONITOR ENABLED. (CIERR 3406)
CAUSE System monitor has been enabled.
ACTION Check system monitor; disable monitor if appropriate.
3407 MESSAGE UNABLE TO FREEZE MEASIO CODE SEG. (CIERR
3407)
CAUSE The measurement interface code segment was not frozen
into memory.
ACTION Retry command.
3408 MESSAGE UNABLE TO "UNLOADPROC" MEASIO CODE SEG.
(CIERR 3408)
CAUSE Measurement interface code segment was unable to
unload requested process.
ACTION Check MEASIO code segment.