MPE/iX Error Messages Manual Vol 1 (32650-90878)

198 Chapter3
Command Interpreter
(CIERR) 1901-12256
address of a device, has failed.
ACTION Call your service representative.
3379 MESSAGE DISCRPS IS NOT ENABLED ON THIS DEVICE. (CIERR
3379)
CAUSE The Rotational Position Sensing (RPS) feature on the
specified logical device has not been enabled.
ACTION Use the DISCRPS command to enable the device.
3380 MESSAGE DISCRPS IS ALREADY ENABLED ON THIS DEVICE.
(CIERR 3380)
CAUSE The Rotation Position Sensing (RPS) feature on the
specified logical device has already been enabled.
ACTION Logical Device is already enabled; it does not need to be
enabled again.
3381 MESSAGE DISCRPS IS NOT SUPPORTED ON THIS DEVICE.
(CIERR 3381)
CAUSE Same as the message.
ACTION Do not use this command for the referenced device.
3382 MESSAGE DISCRPS IS NOT INSTALLED ON THIS DEVICE.
(CIERR 3382)
CAUSE Firmware needed to upgrade disk drives has not been
installed on the device referenced.
ACTION Upgrade disk drive.
3383 MESSAGE STREAMS OUTPUT DEVICE MAY NOT BE 0, CHECK
SYSTEM CONFIGURATION. (CIERR 3383)
CAUSE Device number used was 0.
ACTION Correctly reference device number.
3384 MESSAGE STREAMS DEVICE CANNOT BE A DYNAMICALLY
CONFIGURED DEVICE. (CIERR 3384)
CAUSE Device referenced is dynamically configured.
ACTION Do not reference devices that are dynamically configured.
3385 MESSAGE TIME AND WINDOW SIZE MUST BE SPECIFIED
TOGETHER. (CIERR 3385)
3386 MESSAGE INVALID VALUE FOR TIME-TO-TARGET. (CIERR
3386)
3387 MESSAGE INVALID VALUE FOR WINDOW SIZE. (CIERR 3387)
3388 MESSAGE DISABLE DOES NOT ACCEPT TIME OR WINDOW SIZE,
IGNORED. (CIWARN 3388)
3389 MESSAGE SOFTWARE I/O ERROR. (CIERR 3389)