MPE/iX Error Messages Manual Vol 1 (32650-90878)

176 Chapter3
Command Interpreter
(CIERR) 1901-12256
3058 MESSAGE EXECUTING THIS COMMAND REQUIRES PRIOR
ASSOCIATION TO THAT DEVICE CLASS. (CIERR
3058)
CAUSE The DISASSOCIATE command was used for a device class
that has not been associated with the ASSOCIATE
command.
ACTION Use the DISASSOCIATE command only for devices that
have been associated with the ASSOCIATE command.
3059 MESSAGE ASSOCIATING THIS DEVICE REQUIRES SYSTEM
MANAGER'S PERMISSION. (CIERR 3059)
CAUSE The ASSOCIATE command was used for a device class
that has not been defined in the device class/user
association table.
ACTION The system manager must run ASOCTBL.PUB.SYS in
order to create a device class/user association table.
3060 MESSAGE THIS REPLY EXPECTS ONLY TWO PARAMETERS.
(CIERR 3060)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
3061 MESSAGE REPLY STRING TOO LONG, ! CHARACTERS AT MOST
EXPECTED. (CIERR 3061)
3062 MESSAGE JOBFENCE HAS EXACTLY ONE PARAMETER, THE JOB
PRIORITY. (CIERR 3062)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
3063 MESSAGE EXPECTED JOBFENCE PRIORITY BETWEEN 0 AND 14.
(CIERR 3063)
CAUSE The jobfence priority range specified was not within the
range of 0 and 14.
ACTION Specify a priority between 0 and 14 with the JOBFENCE
command.
3064 MESSAGE PRIORITY < 0, 0 USED. (CIWARN 3064)
CAUSE A negative number was specified as the priority fence.
ACTION None. Information only.
3065 MESSAGE COMMA EXPECTED BETWEEN REPLY PARAMETERS.
(CIERR 3065)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
3066 MESSAGE STREAMS HAS EXACTLY ONE PARAMETER, THE DEVICE