MPE/iX Error Messages Manual Vol 1 (32650-90878)

156 Chapter3
Command Interpreter
(CIERR) 1901-12256
ACTION Reissue the command.
1916 MESSAGE COULDN'T GET UDC FILE LOCKWORD. SETCATALOG
FAILED. (CIERR 1916)
CAUSE Same as the message.
ACTION Reissue the SETCATALOG command using the correct
lockword.
1921 MESSAGE COULDN'T OPEN UDC LIST FILE - !. (CIERR 1921)
CAUSE Same as the message.
ACTION "Unset" the UDCs for that account/user by entering the
SETCATALOG command without specifying a file name
after it. Then reset the UDCs by entering the
SETCATALOG command, followed by the names of the
appropriate UDC file(s).
1922 MESSAGE FWRITE FAILED ON UDC LIST FILE - !. (CIERR
1922)
CAUSE Same as the message.
ACTION Reissue the command.
1923 MESSAGE COULDN'T OPEN UDC FILE - !. (CIERR 1923)
CAUSE Same as the message.
ACTION Reissue the command.
1924 MESSAGE FREAD FAILED ON UDC FILE - !. (CIERR 1924)
CAUSE Same as the message.
ACTION Reissue the command.
1925 MESSAGE IF'S AND ENDIF'S MUST BE PAIRED WITHIN USER
DEFINED COMMANDS. THE PREVIOUS IF NESTING
LEVEL WILL BE RESTORED. (CIWARN 1925)
CAUSE Same as message content.
ACTION None. Information only.
1926 MESSAGE CANNOT SETCATALOG TO AN EMPTY FILE. (CIERR
1926)
CAUSE An attempt was made to use the SETCATALOG command
to establish a directory entry for an empty file.
ACTION Reenter the command making sure the file named with
the SETCATALOG command is not empty.
1927 MESSAGE NO USER LEVEL UDCS HAVE BEEN INITIALIZED.
(CIWARN 1927)
CAUSE Same as message content.
ACTION None. Information only.