MPE/iX Error Messages Manual Vol 1 (32650-90878)

134 Chapter2
Command Interpreter
(CIERR)
1614 MESSAGE EXPECTED "@" OR A PARTICULAR JOB NAME. (CIERR
1614)
CAUSE You entered a syntax error.
ACTION Check the syntax and reenter the command.
1615 MESSAGE JOB NAME MAY NOT EXCEED 8 CHARACTERS. (CIERR
1615)
CAUSE The specified job name was more than eight characters.
ACTION Specify a job name that contains eight or fewer characters.
1616 MESSAGE JOB NAME MUST START WITH ALPHABETIC
CHARACTER. (CIERR 1616)
CAUSE The job name specified did not begin with an alphabetic
character.
ACTION Specify a job name that begins with an alphabetic
character.
1617 MESSAGE "." REQUIRED BETWEEN USER AND ACCOUNT NAMES.
(CIERR 1617)
CAUSE The system expects a period to separate (delimit) the user
and the account name.
ACTION Use a period as a delimiter between the user name and the
account name (user.account).
1618 MESSAGE TELL COMMAND REQUIRES THE ID OF THE JOB TO BE
TOLD. (CIERR 1618)
CAUSE You entered a syntax error.
ACTION Check the syntax and reenter the command.
1619 MESSAGE THERE WAS NO SESSION FOUND WHICH MATCHED THIS
ID. (CIWARN 1619)
CAUSE The session number or session name specified is not valid.
ACTION Determine the correct session number or session name
with the SHOWJOB command and issue command again.
1620 MESSAGE THE SENDER IS THE ONLY QUALIFYING TARGET. NO
MESSAGE SENT. (CIWARN 1620)
CAUSE You are the only user who is able to receive this message
and you cannot send a message to yourself.
ACTION Specify a valid session to receive the message.
1626 MESSAGE SOME SORT OF I/O ERROR IN SENDING MESSAGE TO
CONSOLE. (CIERR 1626)
CAUSE An error occurred in sending the message to the console.
ACTION Send a new message to the console.