MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 129
Command Interpreter
(CIERR)
parameters were ignored by the system.
ACTION None.
1534 MESSAGE EXPECTED ONE OF SP, STATUS, DEV, JOB, ACTIVE,
READY, OPENED, LOCKED. (CIERR 1534)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
1535 MESSAGE STATUS INAPPROPRIATE WHEN OTHER PARAMETERS
SPECIFIED. (CIERR 1535)
CAUSE The STATUS parameter is not valid with any other
parameter.
ACTION To display STATUS information specify the STATUS
parameter by itself.
1536 MESSAGE UNIDENTIFIED PARAMETERS IGNORED. (CIERR 1536)
CAUSE Parameters not recognized by this command were
specified and ignored by the system.
ACTION Specify only valid parameters for this command.
1537 MESSAGE ERROR WHILE USING SCRATCH FILE, UNABLE TO
COMPLETE COMMAND. (CIERR 1537)
CAUSE Same as the message.
ACTION Reenter the command.
1538 MESSAGE TOO MANY ERRORS, ANALYSIS OF COMMAND STOPPED.
(CIERR 1538)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
1539 MESSAGE FILE STATE INCONSISTENTLY SPECIFIED, LAST
USED. (CIWARN 1539)
CAUSE Same as the message.
ACTION None; the message is for information only.
1540 MESSAGE INAPPROPRIATE - INPUT FILES CANNOT BE
DEFERRED. (CIERR 1540)
CAUSE Same as the message.
ACTION Reenter the command but do not specify the input files
when you do so.
1541 MESSAGE THIS PARAMETER APPROPRIATE ONLY FOR "READY"
FILES. (CIERR 1541)
CAUSE You entered a syntax error.
ACTION Check the specified files and make sure that they are in