MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 125
Command Interpreter
(CIERR)
ACTION Provide a valid name for list file.
1496 MESSAGE LIST FILE SHOULD BE LAST PARAMETER OF THE
COMMAND. (CIERR 1496)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
1497 MESSAGE UNABLE TO CLOSE LIST FILE. (CIERR 1497)
CAUSE Same as the message.
ACTION Retry the command using a different list file name.
1498 MESSAGE NOWAIT OPTION IS ONLY VALID WHEN USING
STARTSESS. (CIWARN 1498)
CAUSE The NOWAIT parameter was specified with a command
other than STARTSESS.
ACTION Do not specify NOWAIT with this command.
1499 MESSAGE MUST HAVE SM CAPABILITY TO START A SESSION ON
THE CONSOLE WITH THE "NOWAIT" OPTION. NOWAIT
SPECIFICATION IGNORED. (CIWARN 1499)
CAUSE Same as the message.
ACTION None; the message is for information only.
1500 MESSAGE INAPPROPRIATE TO SPECIFY STATUS WHEN OTHER
PARAMETERS PRESENT; STATUS REQUEST IGNORED.
(CIERR 1500)
CAUSE You cannot specify STATUS with other parameters.
ACTION Specify only the STATUS parameter to display this
information.
1501 MESSAGE UNKNOWN PARAMETER TO SHOWJOB. (CIERR 1501)
CAUSE Parameter specified is not valid with the SHOWJOB
command.
ACTION Specify only valid parameters with the SHOWJOB
command.
1502 MESSAGE EXPECTED JOB IDENTIFICATION. (CIERR 1502)
CAUSE When you specify #J you must specify a job identification
number.
ACTION Specify a valid job identification number.
1503 MESSAGE EXPECTED JUST "@S". (CIERR 1503)
CAUSE More than just the @S parameter was specified.
ACTION To obtain information for sessions specify the @S
parameter.